Flush Floor
Outlet Trunking
|
 
 |
| |
| Service Outlet Module |
| |
The service outlet module is made up of three component parts.
- A section of trunking lid and the socket plate carrier.
- A carpet frame and lid.
- Four short lengths of trunking divider.
Trunking Lid and Socket Plate Carrier
A 500mm length of trunking lid into which a rectangular hole is punched to accept the moulded carpet frame. Attached to this section of lid is a galvanised metal frame which carries the socket plates.
This length of lid is interchangeable with the standard lengths used on the trunking.
Carpet Frame and Lid
A carpet frame and hinged lid manufactured from ULTRAMID B3 - PA6 plastics that are Halogen free and conform to fire classification UL94 V2 (3.2mm). The lid which is reinforced by a 2.5mm steel plate has a carpet recess of 6mm and carries three individually hinged cable outlets and a moulded handle.
Specifications
Trunking lid and socket carrier manufactured from 2.5mm and 1.2mm respectively, self-coloured pre-galvanised steel sheet to.
BS EN10142:1991.
Fe PO2G Z275NAC.
BS EN10143:1993.
Ordering Information
The three compartment module is supplied with the following as standard:
- One twin-switched 13A plate and a 13A panel mounted socket No. AXP55/3
- One standard 4-way RJ45 plate No. AXPRJ45/3
- One blank plate No. XPB/3
The four compartment model is supplied with one socket plate, two blanks and a choice of data plate.
|
|
|
| Non Standard Service Outlet Modules |
| |
| Non-standard service outlet modules are available to order. Variations are available as follows: |
| Compartments |
2 and 4 compartment. |
| Finish |
Carpet frames can be manufactured in brass, stainless steel, or finished in chrome plate or in a wide range of powder coated colours. |
| Application |
Modules can be manufactured to fit floors covered by carpet, vinyl, terrazzo,
and other forms of ceramic floor tile.
If you have a non-standard requirement please contact the Armorduct sales office or your Armorduct Sales Manager. |
|
|
|
